The VLXS10 is your solution for quick service operation on today's passenger cars and trucks up to 10,000 lbs. Tire and brake work can now be performed on a wider variety of vehicles, thanks to the newly designed pads and adapters, wider drive-over capability and increased lifting capacity.

The pad and adapter combinations allow lifting of uni-body and frame contact undercarriages - reaching recommended manufacturers pick-up points on most vehicles on the road today.

Trucks and SUVs that require a wider drive-over capability will not be turned away. The VLXS10 has ramps and side drive-over areas to accommodate wider wheelbase vehicles.

The 10,000 lbs. capacity offers the ability to lift the heavier vehicles being sold today. The VLXS10 is truly the heavy-weight winner when comparing mid and low-rise lifts.

VLXS10 Adapters
The new three-position adapters have rubber contact pads on three sides increasing the positioning capabilities. The height added by these adapters excels the versatility of the lift. The adapters can be laid flat for 4 5/16" (110mm) additional height or on the side for 6 5/16" (160mm). Achieve maximum extension by laying the adapter on end and allowing an additional 8 9/16" (218mm) of height. The VLXS10 also comes with a set of four 1 1/2" rubber block adapters for low-profile vehicles.
 

VLXS7 Adapters
The 7,000 lb. capacity low-rise lift comes standard with a set of rubber blocks for quick access to lower profile and unibody frame vehicles. Blocks are 1 1/2" and 3" in height.

LOW RISE MODELS AVAILABLE